Servo driver PWM PCA9685 16 canales.

Servo driver PWM PCA9685 16 canales.
Modelo: servo driver-2078
Puntos: 2
Disponibilidad: 4
Precio Neto: $10.500
Valor Neto: $10.500
Precio en puntos recompensa: 14
Cantidad:     - O -   Añadir a la lista de deseos
Comparar

Servo Driver , 16-Channel , 12-Bit Pwm -PCA9685 For Arduino


Description


 You want to make a cool robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts.

Or maybe you want to drive a lot of LEDs with precise PWM output.

Then you realize that your microcontroller has a limited number of PWM outputs! What now?

 Using only two pins, control 16 free-running PWM outputs!

You can even chain up 62 breakouts to control up to 992 PWM outputs

• It's an i2c-controlled PWM driver with a built in clock. That means that,

unlike the TLC5940 family, you do not need to continuously send it signal tying up your microcontroller,

 its completely free running!

•It is 5V compliant, which means you can control it from a 3.3V microcontroller and still safely drive up to 6V outputs

 (this is good for when you want to control white or blue LEDs with 3.4+ forward voltages)

• 6 address select pins so you can wire up to 62 of these on a single i2c bus, a total of 992 outputs - that's a lot

of servos or LEDs

• Adjustable frequency PWM up to about 1.6 KHz

• 12-bit resolution for each output - for servos, that means about 4us resolution at 60Hz update rate

• Configurable push-pull or open-drain output

• Output enable pin to quickly disable all the outputs

We wrapped up this lovely chip into a breakout board with a couple nice extras

• Terminal block for power input (or you can use the 0.1" breakouts on the side)

• Reverse polarity protection on the terminal block input

• Green power-good LED

• 3 pin connectors in groups of 4 so you can plug in 16 servos at once

(Servo plugs are slightly wider than 0.1" so you can only stack 4 next to each other on 0.1" header

• "Chain-able" design

• A spot to place a big capacitor on the V+ line (in case you need it)

• 330 ohm series resistors on all the output lines to protect them, and to make driving LEDs trivial

• Solder jumpers for the 6 address select pins

Escribe una opinión

Tu nombre:


Tu opinión: Nota: HTML no está traducido!

Puntuación: Malo           Bueno

Introduce el código en la casilla inferior:



Tienda de arduino Online Concepcion Talcahuano Hualpen | Despachos a Santiago, Viña del Mar, Valparaiso, y regiones © 2024
Powered By arduconce